framing

[dawnnelson69]

I've had a few problems when I buy frames from like hobby lobby it has no backing on it. I'm fairly intermediate when it comes to cross stitching but I just can't figure out how to frame properly. The frames I get are generally roundish and just the frame itself nothing else. Any advice would be greatly appreciated.

[Reta]

You need a piece of Acid Free board cut to the size you want to fit the frame

Then stretch the finished piece over it

Instructions

http://www.squidoo.com/how-to-stretch-m ... e140950711" target="_blank

[dawnnelson69]

You need a piece of Acid Free board cut to the size you want to fit the frame

Then stretch the finished piece over it

Instructions

http://www.squidoo.com/how-to-stretch-m ... e140950711" target="_blank" target="_blank

Thank you Reta, I'm reading a little bit of the site now and it looks very informational. It looks like I've found a new way to frame, thank you again so much.

[ChristineHinderer]

These instructions for stretch mounting are nice and clear. I think I can do this.

I am new to this site and I really enjoy the ability to search for keywords.